BSG 1978 - Colonial Blaster (Greebled) Display Stand

I designed this stand because the one from the Dutch Cylon was to big for my bookshelf and took up too much space. This unit includes a spot for the three recharge cylinders made by the Dutch Cylon as well.

The first plain version I made was a bit boring, so I created this Battlestar Greebled Version

*******If you want one that fits the more common smaller versions of the Colonial Blaster, I am also releasing a "BSG 1978 Display Stand - MOD Parts" for the Plain and Greebled versions of my stands that include the 4 parts that have been changed.*********

I was originally going to make it large and print it as one piece on my Prusa XL, but decided to make this eleven piece modular unit that could be printed for anyone with smaller printers.

There are indents and guides and dovetails for the parts, but glue will still be needed.

1. This model prints fine at 0.2 Layer height and 15% infill.  The plaque is printed 100% infill.

2. Support material will be needed on the "CBDS_Greebled_Right_Top", "CBDS_Greebled_Left_Top",and "CBDS_Plain_Cradle_Base".

3. The "CBDS_Greebled_Support_Peg_Base" will have to be glued to the underside of "CBDS_Greebled_Left_Top"

4. A small set of clamps is helpful when gluing the base parts.

5. The right and left tops will need to be slid together before putting them on the base.

6. The Center Greeble will need to be glued to the center of the tops.

7. The plaque holder needs to be glued to the Plaque, then to the spot on the greebled tops.