ultrabook stand - vertical (open 180º)

Initial upload 2-15-21: A stand for Dell Latitude Ultrabook for the fully open laptop (180º) to allow raising it to eye level while using an external keyboard and mouse. This configuration saves a ton of desk space. Have used every day at work and home since printing it. It's surprisingly stable and unobtrusive.

Use Rev.1 0.5 mm wider gap for not as snug a fit in case the rubber feet on the back of your ultrabook are brand new and protruding too much.

Please note the share alike + non commercial license. Please don't try and make money off my hard work.

If you want to modify and create a derivative I provide the original Tinkercad design. Please pass along the CC share alike non commercial license to any derivative work.

Update 4-20-21: Use V2 for a faster print (3 hrs vs. 5-6 hrs) and slightly less material used. (tinkercad here)

Update 8-17-21: have been using both designs daily, V1 at work and V2 at home since February 2021, with zero issues with either design.

It's so simple to print even I could do it, please post makes! :)

Print Settings

Printer:

Sovol SV01

Rafts:

No

Supports:

No

Resolution:

0.2 to 0.3 adaptive (Cura)

Infill:

10% gyroid to 15% rectilinear

Filament:

White

Notes: