RailCore SlipFit Electronics Box

When I decided to reprint the RailCore Electronic Box corners in a different color, I figured in true RailCore spirit, I'd just redesign everything.

The corners do not require screws to hold in the sides as they just slide in and include a loft to support the top so no supports are needed.

There is a middle connector to fit the existing holes in the kit ZLT. It is not required for the ZL.

To allow access to the USB and SD card, there is a slot in the top front side.

The top rear side is modified to fit the power input that comes with the kit.

The bottom front, only for the ZLT, has a Decora on/off switch to make it easier to reach than the one in the back.

The bottom rear, only for the ZLT, has a convenience outlet to plug extra things into.

Print Settings

Printer:

RailCore or BigBox

Rafts:

No

Supports:

No

Resolution:

.4mm nozzle

Infill:

15%

Filament:

Silk Grey