Petsfang Right CR Touch Mount

My first remix of the right probe mount for the petsfang base

Mount did not fit the CR Touch well so I made some modifications to allow clearance of the ribbon cable, and removed the middle hole as it was useless

1/2/22: Realized that the probe still did not clear completely. Will edit to fit better. Will also make the probe sit lower down so nozzle isn't so close to the bed

1/4/22: Uploaded a stretched version. Made the mount holes slightly smaller so you might be able to get away with reusing the stock screws

1/8/22: I edited the left side mount for better UBL purposes. It fits tighter than I would like (and pushes against the duct very hard) but once installed is very solid. I will probably be editing this a bit later on