Clip for blinds topper

Replacement clip to hold top two blinds slats. The original is on the right.

Check out the other things I created. https://www.thingiverse.com/GerryPB/about

A360 file
http://a360.co/2Adv4ah

Print instructions

Category: Household Print Settings

Infill: 100%

How I Designed This

Steps to create model

I layered paper over the original and rubbed it down with a pencil. I added the red lines parallel and square with 50mm reference marks. Then it was scanned on a flatbed.

The scan was cropped and rotated to be parallel.

It was imported to fusion 360 as a canvas then calibrated using the 50mm marks.

After that it was easy to create a sketch over top