Clamp Holder

I made two models:

- “Support Pinces 15mm” allows you to insert the clamps freely. If you turn the holder upside down, the clamps may slide out and fall.

This is sufficient if your pliers are always on the same desk or workbench.

- “Support Pinces 16mm” requires you to open it slightly to insert or remove the clamp. This is practical if you need to transport your clamps from one place to another. The clamps will not come out of the holder on their own.

This model is an addition to the original model. It does not replace it, and you must download and print the original clamps.