a regular/mini rc car ramp

this is a rc car ramp that I took several hours to design hope you like it...

just print two legs and one ramp and use superglue to attach the pieces

make sure to use in an open area because this ramp ts angled at 30 degrees and our car will fly at a high speed!!!! 

for the legs I recommend to use pla or petg with supports and outline around the model to help it stick on the bed, and the actual ramp if you see it doesn't require supports, but I strongly recommend the outline around the model because the edges can curve up from the heat of the build plate especially for petg because the bed plate will be about 80 Celsius (almost 200 degrees fahrenheit)so it can curve up 

thanks for printing!!!!!!