Snow Gauge
Snow Gauge - each ruler goes to 8". To double the length, print off the blank panel and super glue to ruler backs.
7
35
0
191
aktualizováno
24. ledna 2026
Popis
PDFWith snow storm expected tomorrow I created this snow gauge. I was worried about wind blowing it down, so I created the base in Tinkercad with two lips to fit into the slots on my patio table. I included a rectangle and circle base for anyone else to use though.
Štítky
Původ modelu
Uživatel se označil za původního autora tohoto modelu.