14 Different Jog Dials and Knobs for IKEA Bilresa Scroll Wheel Remote

Intro

These are some designs for improved usability and/or improved fun factor for the Bilresa scroll wheel remote.

The idea is to stick them onto the scroll wheel by either using double sided tape - or if you prefer a more permanent improvement - even glue.

I guess, only a few of these might really be useful, but it was fun to take the idea a bit further...

Printing

For the spherical jog dials I would recommend to use a height modifier to increase the perimeters for the last layers. This should result in just concentric rings with no linear top layer in between.

The windup key prints in two parts (I really try to avoid printing supports) and is meant to be glued together. If you want the key to be bigger, you can scale it in the slicer in x- and y- direction.

The big knob prints in two parts, the ring upside down (big chamfer facing the bed). It is meant to be a snap fit and worked nicely for me (it is designed with a 0.1 mm gap + 3 tabs). If the fit is too tight, I would recommend scaling up the ring slightly.