Ryobi TS100 Soldering Station with DC jack, storage clips and cable organizer.

A remix of the wonderful design of JeffWDH, This one expands to cable hole so that you can use a barrel jack. It also adds optional clips to store the iron when not in use, also 2 holes so that you can route a velcro strap through to store your cable.

Rocker switch: https://www.amazon.com/dp/B07Y1GDRQG

Keystone connectors:https://www.amazon.com//dp/B06VTPWM6M/

Power Jack: https://www.amazon.com/dp/B08SJM2G52/

Velcro straps: https://www.amazon.com/dp/B001E1Y5O6/

I believe I used a 3/4 inch galvanized washer for the holder.

Copied from the original design since it prints the same.:

Printing instructions:

Base:

Print battery side down

Supports for the battery post and power switch hole

Top:

Print top side down

Support in the tip cleaner hole

Holder

No support needed

Print standing up

Print Settings

Printer Brand:

Creality

Printer:

Ender 5

Rafts:

No

Supports:

Yes

Resolution:

.28

Infill:

20

Filament: GST3D PLA Orange