Blackmagic Micro Converter Mount

Model

This is a right angle bracket and nato rail to help attach a Blackmagic micro converter to your rig, tripod, drone or live streaming station. The bracket uses the original screw holes to securely attach to the adapter.

Parts needed

2 x m3 8mm countersunk screws

Installation

(1) Remove the two M3 Phillps screws from either the right or left side

(2) Attach the right angle bracket or nato rail

(3) Screw in the bracket using longer (6mm - 8mm) M3 countersunk screws to attach the bracket

Disclaimer

Adding this bracket and removing the two screws should not void your warranty, only removing the two screws will still keep the metal cover attached so there is no risk of damaging the converter. (Using screws that are too long will collide with the hdmi and sdi ports, if you tighten them hard enough you can possibly damage these connectors)

Print Settings

Supports: 

No

Resolution:

0.12

Infill: 

20%+

Filament: Any PLA, PETG or Nylon Any

Notes:

I would highly recommend printing the nato rail with 4+ walls and a strong, stiff filament like PLA, Nylon or PETG.