Onewheel XR Classic Stand

This is a simple stand I modeled up for the Onewheel XR Classis as a single extrusion. I modeled it around the stock footpads and bumpers that come with the XR Classic. This might work for the GT or pint, but I have not tried it. I printed in PETG with 3 walls and it has been holding up well with normal use.

It's similar to other stands out there, but I made a few tweaks unique to the XR Classic and added a couple features I wanted in the stand.

• Features:

  • Ledge on the rear face to hold a GT charger off the floor (still allows normal cooling and airflow for the brick.

  • Two raised features where the end of the board sits in the stand (helps center the board and prevent it from falling over.

  • No supports needed.

  • Sized just right for the XR classic to keep it snug and in place when standing up.

  • Steep angle so the entire weight of the board isn't resting on the front lip and bumper side of the stand.