28mm Monk Miniature w/Heavy Staff

Monk with Heavy Staff miniature for tabletop gaming.

I make no claim to its creation, and found it at:

http://www.123dapp.com/123C-3D-Model/Monk-Heavy-Staff/1102384

I scaled it to approximately 28mm 'heroic' size, and gave it a proper base.

Print instructions

Category: Toys & Games Print Settings

Printer Brand: RepRap
Printer: Wilson
Rafts: No
Supports: Yes
Resolution: .05 mm layer height and .25 mm nozzle
Infill: 100%

Notes:

Lay it on its back, with the (model's) left upper arm parallel to the build plate. With Cura, I used grid supports everywhere. Make sure the right arm is supported. Lots of support material and rough surfaces on the back. Special care must be made when removing support material around the staff, as the wrist is a little weak. I've thickened the wrist up a little from the original, but it's still printed at a 45 deg angle, and won't take a lot of abuse.