How to insert/orient the organizer (IMPORTANT)
The insert is asymmetric and is meant to fit the box tightly!
If you insert it into the box and it wobbles around – rotate it 90 degrees and press it inside, it'll push the forward and back walls a bit and will sit there.
It's supposed to fit tightly in one axis but at the same time leave enough room on the left & right sides for the “flaps” of the box's cover. See the pictures.
My print settings
(to get what you see on the pictures)
Nozzle: 0.4mm
Preset: 0.20mm Quality
Layer height: 0.20mm
Infill: 10%
Infill patter: Rectilinear
Perimeters: 3
Top & Bottom Layers: 0 (to reveal the infill pattern)
Print time: ~2.5h
Orientation: upside down – legs up!
Support: No
Dimensions
Bottle hole DIA: 26mm (for 25mm bottle)
Width: 199mm
Length: 203mm
Hight: 30mm
Please leave a Like🤍 if it worked for you.
Iteration on such designs consume a lot of filament, so could use some prusameters :D
The author hasn't provided the model origin yet.