Modified the front lights and other small improvements

Modified the hood so the front lights face forward and added 2 more, really like how the LEDs look when they face forward and they also provide more light, same 5mm LEDs and 5mm LED holders can be used. they fit rather snug but depending on your printer you might need to use a drop of glue so they stay flush.

Made a channel in both boom arms so wires can be hidden, a long extension for the claw servo can be used, i suggest fishing it through both arms and at the claw end make it so it comes out about 2cm, plug in the servo (servo wire needs to be shorten) to the extension and then push it back a bit, that way if you ever need to service the claw you can pull it out and unplug it.

I hate seeing wires and made a cover for the motor, when soldering the wires to the motor make sure they are close together and the cover will fit nicely, a 2x8 screw can be used.

Made holes so LEDs can be fitted to the loader boom and wires hidden inside the boom. Now there are 2 choices, either use the normal white LEDs but they do not provide enough light to brighten up the grabbing area or you could use 5mm F5 diodes (https://www.aliexpress.com/item/1005007123108878.html?spm=a2g0o.order_list.order_list_main.35.67dd1802gzecDS) which are super bright and perfect for this, I included LED holders for the normal 5mm LEDs and also for the F5 ones.

Made some cab windows, the rear and side ones fit rather snug so glue is optional but the fronts need a drop of glue on the inside, i left the drivers window open so the inside can be seen.

Front lights face forward and added 2 more, Boom channel so wires are hidden, Boom Led holder, Cab windows, Rotating claw cover