xTool F1 Ultra 90 Degree Exhaust

This exhaust port replacement for the xTool F1 Ultra lets you connect the stock 3" hose directly from above. My workbench sits against a wall and is only 18" deep, so with the hose coming out the back and angled upward, the engraver bed was hanging off the edge of the table. With this 90-degree duct, I now have about an inch of clearance before the edge of the bench. You can potentially rotate it left, right, up, or down depending on where you want the exhaust hose to run.

Note: You’ll notice two small indentations on the sides of the duct. These recesses are intentional and allow the mounting screws to pass by without the screw heads rubbing against the duct.

Removed the fan delete and added a 90 degree elbow then reused the existing interface for the stock 3" hose connection in the new orientation.