Simple band/belt shuttle for Inkle or tablet weaving

This is a simple, lightweight band/belt shuttle designed for Inkle/Tablet weaving. The shuttle has a bevelled edge for beating the weft into place. The shuttle is 125mm in length and is 7mm at its thickest edge. 

I printed this on my Bambu P1P printer using eSun PLA+ with the following settings:

• 0.2 layer height

• 20% infill

If you want it stronger, then you could print it at 100% infill, but I found that 25% works for me. Let me know if there is any modifications I should do.