Cobra Adder 1913 picatinny folding stock adapter

This is to put a 1913 picatinny folding stock on your Cobra Adder crossbow.

This model does fit snug so don't feel shy about using a machinist's hammer with a rubber tip to knock it down in there.

(To remove you may need to pry it out little by little rotating around the model, DO NOT try to break it off.)

(if you don't want it so snug then size it down a little but not much you don't want it wiggling around.)

Any picatinny stock will work but amazon has some very high quality aluminum stocks that are considerably cheaper than buying the ones from 1913stocks (unless you want one of those). 

The material is PLA+ or STRONGER, you should use at least 30% infill but I recommend 100% and Use supports. 

Post print: remove supports AND built in tabs from the shaft and nubbin.