Dyson V15 Accessory Holder 6-port

Ideas and geometry from both @HopefulMonst_1088490's original V10/V11 models and @awitten_2843089's V15 remix with some printability changes and tweaks to ensure it fits on a 256mm bed and can print as one piece. This model has spots for 6 accessories.

Original Spring Clip file included with no modifications.

See notes below for all the changes made in the remix.

Recommend printing with 4 walls in PETG and 10-15% cubic or gyroid infill.

Ideas and geometry from both @HopefulMonst_1088490 's original V10/V11 models and @awitten_2843089's V15 remix.

• Spacing for V15 charging dock, flat design with 6 ports (fewer than even @awitten_2843089's “less ports” version).
• Prints as one piece arranged diagonally on a 256mm bed. Tweaked spacing and corner radius to make it fit on 256mm like @HopefulMonst_1088490's V10/V11 versions.
• Added some cavities for filament savings, extra fillets for smoother acceleration and aesthetics
• Lower height on the four ridges on the top insert as original geometry prevented accessory from clicking into dock by about 1mm.
• Spacing of right-most accessory port matched to left-most port (entire accessory is symmetrical) also to ensure it would fit onto 256mm bed