GEELY EX5 EM-i clip

The car dealership placed an order to scan a Geely roof rack and make an identical one on a 3D printer, as it had been damaged during transport on a car transporter. The scan turned out terrible, as the roof rack is hollow inside. However, the clips were successfully scanned, and after minimal processing, they fit perfectly into the mounting locations of the original roof rails. Since these clips are very difficult to find and break as easily as any other single-use, double-use, or triple-use Chinese clips, I am posting the model here.

print how it is located on the table, with regular support with 5mm spacing between support lines