Vacume tubeholder

This is a tubeholder replacement i made for work because the original one got lost somehow. The vacumecleaner in the picture is a Nilfisk vacumecleaner, but i think this part will fit most vacume cleaners.

I printed the part in petg without support. I printed with 30% infill and i used a m4 screw of 25mm long and a nut for the slotpart that slides into the slot on the vacumecleaner. Without the screw i don't think it could handle the stress from holding the long tube upright.

I hope this part is usefull to other people. If so, please share your make images :-)