Minecraft Torch

This is a Minecraft torch that is designed to use the standard Harbor Freight LED Mini flashlight. The plunger sticks out a little ways past the bottom of the base so you can tun them on and off while they are in the wall mounts.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Supports:

Infill:

Notes:

Post-Printing

Paint the base by giving it a base coat of paint. After that dries, cover the base in masking tape. Then cut the tape along the grooves with a razor blade. Remove random squares and repaint with another shade of brown. Repeat this process with the Lens using red and orange. Glue the lens onto the base. Remove the lanyard from the flashlight and insert it into the bottom hole. Add the plunger long end first. Apply some Teflon plumbers tape to the screw lock to get the tightness to your liking. Screw in until it just rests on the plunger. The slot is sized to a US .25 coin. If you can't turn the light off after turning it on, back the screw off a bit to allow the tail switch to reset.