No Drill Universal Wall Mount for Speed Champions Die-Cast & Building Block Cars

Mount and display Speed Champions-size building block cars on the wall without drilling. This mount is designed around Command hook-and-loop picture hanging strips and uses two “Small” pairs per mount for a strong hold.

What you need (per mount)

• 2 pairs of Small Command hook-and-loop strips
  (4 total strips — 2 strips on the mount, 2 strips on the wall)

Amazon

Adhesive / Recess tip (IMPORTANT)

This model has strip recesses on the back. For best results, it’s recommended to glue the strip pads into the recess so the strip backing can’t peel away from the print over time.

Glue recommendation (safe way):

• Use a small amount of CA (super glue) or epoxy

• Glue only the strip pad to the plastic recess (do not glue anything to the wall)

• Let cure fully before mounting

⚠ Note: Gluing the strip pads to the mount may reduce the “easy remove” behavior of some Command products and can increase the chance of wall damage depending on your wall paint/texture. Use at your own discretion.

Fit

• Designed for Speed Champions-size building block cars

• Car dimensions vary slightly between sets; this is intended as a “fits most” display mount.

Print settings (recommended)

• Material: PLA or PETG (PETG recommended if the room gets warm)

• Nozzle: 0.4 mm

• Layer height: 0.20 mm

• Walls: 3–4

• Top/Bottom: 4–5

• Infill: 20–30%

• Supports: None

• Orientation: print flat as modeled