O.C. White ProBoom Ultima Gen2 LP Stand

The Ultima Gen 2 from O.C. White doesn't come with any mounting solution, and I didn't feel like paying $80 for a desk mount from O.C. White themselves, so made my own solution.

I was coming from a Elgato LP boom arm, so I designed the “neck” on the mount to be roughly the same height as the mount from Elgato. Your mileage may vary.

Printing recommendations:

• Material: PLA or PLA+ (strong, rigid, no need to worry about low glass trans. temp)*
• Nozzle temperature: Slightly higher than usual to promote better layer fusion
• Infill: Solid
• Layer height: 0.15
• Perimeters: 4 or more
• Supports: None
• Orientation: Right-side up

*PLA can deform over time, even at room temperature, if left under load. I'm still testing this myself. If it turns out to be a problem, I will likely switch to an ASA printed part (PETG would likely work as well, but I don't use it so I can't say for sure).

Fastener hardware recommendations:

• Mounting holes: The holes are cut for countersunk screws with a ~9mm head that tapers down to ~4.5mm. The screws you choose, however, will vary depending on what you're fastening to.
• Retaining hole: M3 bolt or grub screw

(Optional) I also applied some multi-purpose synthetic grease to the boom arm insert to make swiveling action smooth and low-wear. Probably not necessary, but it can't hurt.