Lever n°4 for Virpil Joystick Grips

Press Like for encouragement. Comment for improvement.

With the DCS module Mi-24 being released, I wanted the matching joystick. I added the missing brake lever to the WarBRD joystick.

Materials:

• M3x 10mm bolt + nut.
• M3x 16mm bolt + nut.
• an optional compression spring (5mm in diameter, 20mm in length and 0.8mm wire diameter).
• a rotary potentiometer.
• 5-pin JST PH male connector (plugged into the Virpil base).

Electronics:

Plug the potentiometer wires either:

• on an Arduino Leonardo/Pro Micro, get the joystick library and follow the examples in Arduino tutorial chapter 3.
• on a Leo Bodnar BU0836,
• on the Virpil base board:
  • Check first if your circuit board looks like mine on the picture. 
  • On the joystick's base, look at the bigger circuit board. Look for the 2x 4-pin connectors (1 on each side, each one for a hall effect sensor) There are 2 free pins next to them. That's where the signal from the potentiometer goes. Take the + and the ground from the free “AUX” 5-pin connector. Check the picture for more details.
  • When the wiring is done and the grip is connected, open the VPC Configuration Tool, define 2 new axis (double click on a free axis) and calibrate them. That's it. Just take your time, it's easy.

→ Extension with a hole for the wires.