20 mm leg extensions for IKEA BRATTVÅG Bed Leg

20 mm extensions for the IKEA BRATTVAG bed legs.

I bought a new cleaning robot, which is a few mm higher than my old one and this haad problems to get under my bed. So I designed this extensions to higher my bed for 20 mm. I tried t design them, so they match the style of the legs.

You need to print one extension per leg. I used 3,5 x 25 mm wood screws to attach it to the bottom of the leg. I also glued felt pads underneath.

Print Settings:

• Perimeters: 4

• Bottom and top layers: 5

• Infill: 25-30%

• Infill pattern: gyroid

• Now support needed

I used ABS because at the moment I do not have black PLA, but I think PLA should be also sufficient with this print settings.