CordMate II coupler

I needed an additional coupler for my wall-mounted Cordmate installation, and I didn't feel like driving to Home Depot for a $2 part. I found this coupler with a screw-in mount which was close to what I needed. I didn't need the screw-in mount, though, so I used TinkerCAD to remove it.

This is my first remix, so it was also a learning exercise for me. It's not a perfectly clean modification as I couldn't get TinkerCAD to fully remove the part closest to the coupler. I don't think you would notice it without getting up close to the wall. I was able to modify the final product a bit so there's no remnant of the screw-in mount.

I used Bambu Matte Ivory White PLA, 0.24mm draft mode. 

Photos show the printed model with the original CordMate II coupler next to it.

Removed the screw-in mount so it looks like a plain Cordmate II coupler.