Germitation set

Create a germitation set with this print. It consists of two parts;

• Holder 
• Strainer

You'll also need a bottom part of a PET bottle acting as water reservoir

The strainer is based on the PET bottle sief and the included project code contains the pre-configured projects and gcode (original STL also included. The strainer rests on the holder 

The holder has two sides, one side is the be put on top of a PET bottle. I used a 1,5l coke bottle here. The other side of the holder has support for holding the strainer.

I tested the model with cress seeds and to ensure they are not falling through. Smaller seeds could potentially needs a higher mesh density

The holder size can off course be adapted as well with scaling to a higher or smaller diameter