PrusaBox Enclosure - Buck Converter box with WAGO holders, RJ45 Network Port, Enlarged Rocker Switch Opening

Note: Please see my remix  https://www.prusaprinters.org/prints/155787-prusabox-enclosure-enlarged-buck-converter-box-wit for an enlarged version of this same design to more easily fit all the wires with the relay in the lid.

This is a customized version of the PrusaBox Buck Converter box.  Things that were customized are:

1. The opening for the rocker switch was enlarged as I couldn't easily get the size that was in the original design.  I enlarged the opening to 19 mm x 12.6 mm. I'm in Canada, so the switch I used is on Amazon at https://www.amazon.ca/gp/product/B07Y1GDRQG
2. Added a modular coupler for a RJ45 network plug.  Here is the coupler I used. I think these are fairly standard size so hopefully other brands would work.  The coupler is inserted with the clip on top. https://www.memoryexpress.com/Products/MX41753
3. Added holders for WAGO connectors to clean up the wiring, and make attaching wiring more easily.  There are two 5-conductor connectors, and one 3-conductor connector.  The main positive and negative 12V wires from the buck converter feed into the back of the custom holder and up to the top.  The positive connects to one of the WAGO connectors, and the negative connects to another connector. Note that I do not want to take credit for this WAGO holder design.  I found a version of this holder on Thingiverse at https://www.thingiverse.com/thing:4635919 and want to give credit to Thullen.  I just modified this design to add another 3-conductor at the end, and make modifications so I could mount it in the buck converter box, and added a hole at the back to allow the power leads to feed from the back rather than through the bottom.
4. Made a wire access hole at the end of the buck converter box to more easily feed the USB cable to Raspberry PI, and the network cable.