Delta X5 Planer Dust Chute

I grew tired of the default dust chute putting the hose right on the outfeed table, so I designed a better one.  Note: the X5 is symmetrical, if you want the hose on the other side just mirror the print.

Note: I made a few key modifications to get this to print on my Prusa XL:

• Use organic (tree) supports, but change the branch diameter angle from 5 to 10 and change the first layer density from 80% to 100%.  This gives it a much stronger footprint.

• Rotate the model to be "face down" on the "face" that's the rectangular opening.  Then rotate it up 15-25 degrees or so (enough so that the top doesn't need supports), then rotate 45 degrees to fit it sideways on the build plate.  

• I used the .32mm SPEED profile but added a perimeter so the walls were solid, and was able to double all the speeds so it prints in about 11 hours.