Big Lego Christmas Tree

Lego Inspired christmas tree

Small tree to put anywhere you want to keep the christmas spirit.

Designed to not need glue or supports*. (could not get the star to be without supports without making it more complicated than it needs to be or way bigger. )

all parts are oriented the correct way and will fit on any printer same or bigger than te Prusa MK3/4/S/+.

Tree is about 30cm (1 foot) tall.

Scale is about 3,75:1.

community challange

• add more ornaments 

• improve the design

• share you thoughts and results

assemly tips

• there are small flat surfaces on the pieces to keep the tops of the studs from spinning.

• the ornaments can be placed on the bottom of the leaves.

• some of the stud tops  may be loose, you can add a bit of glue if you want but is not needed.

•  the studs may rotate, a bit of tape fill fix this.

printer/settings

• Prusa MK4S

• 0.2 mm structural 

• support is only needed to print the star.

Filaments used

• ESUN PLA+ Pine green

• ESUN PLA+ Blue

• Prusament PLA Pineapple Yellow

• Prusament PLA Simply Green

• Prusament PLA Lipstick Red