Spool Holder (external feeder for Flashforge Adventurer 5M Pro)

Sized to fit 1KG filament roll that can freely rotate without worrying about snagging. Remove beam and place through your filament roll, place back onto the spool mount- and done!
Super easy to install and swap filament as needed.

Note:
Cannot be mounted on the wall, was designed for mounting on a table or shelf.

The honeycomb structure makes it easier and more cost efficient to print, without losing any sturdiness.
The beam should be printed with a minimum of 8% infill to be able to hold 1KG filament rolls.

Tested and Printed on:
Flashforge Adventurer 5M Pro, using PLA/PLA+ filament.