Mini mic tripod for 5/8" (US) thread

Made this because the 3/8" thread standard used by other mic stands is too flimsy for 3d-printed threads (in my experience). Most US mic mounts have a 5/8" thread with a 3/8" adapter that you can remove.

Print upright without supports but obviously it needs GOOD BED ADHESION. My recommendation is PLA+ on a smooth PEI bed, prints flawlessly on my Prusa.

Made to sit on a desk/table:

• Legs are 72mm from center (fill 144mm diameter circle)

• Height with thread: 68mm

• 8mm of exposed thread