Custom gridfinity kitchen drawer organizer for BLUM drawers

I made this custom organizer for my BLUM 50 cm (50 cm = usable space between arches) drawers in kitchen because pretty much what i found on the internet did not fit. These drawers have specific arch at the both sides so I had to adapt my models in a way that it does not rattle around.

I did not want to use any glue or magnes or any permanent fixing to my drawers due to custom fitted kitchen.

The whole cutlery is basically 3 years old ikea, except like 2 knives. So perhaps standard ikea cutlery that you can get nowadays might fit.

I fitted all of that on Optimized gridfinity base by JMAW. No magnets, no glue. It just holds in place by its own weight. Fit in the drawer is tight enough so the bins do not rattle or move around. 

Because i reverse designed gridfinity base from documentation available at Zacks official page to optimize print times, I cannot confirm the fit will be good enough for other baseplates, but it worked well enough for me with plates from JMAW.

Some models require slicing, some are pre-sliced to fit smaller plates. You can just use whatever slicer you use and send it down the grid middle to separate parts that are too big for your printer.