Sculpfun iCube Ultra clamp & alignment set

The Sculpfun iCube Ultra Laser comes with a non honeycomb cutting plate - this makes it difficult to clamp down wood or other parts. I Found no other solution out there so i made one myself.

I Printed the whole set in PETG.
0.2mm
no supports needed

The 2 long bars on the sides are glued with 2k epoxy glue.

Needed Hardwareparts:
- 2K Epoxy glue or other glue for the 2 side bars
- as many as possible threaded inserts -> M3x4x5
- Round 5x5 Magnets for the Bars
- string magnets for under the plate, i use 20x10x3mm (to fix the bars,L-Bars if you use them
- without height_wedge i use M3x8mm