This part broke after the car hit against an obstacle. Disgned this quick'n'dirty and will use it until the next order. The original spare parts costs just a few bucks. Replaces one part in this set: C-00180-036 I removed the stairs effect from the 0.2 layers with sand paper. Maybe it's a good idea to try 0.1 layer next time.
UPDATE: One hard crash later, I had print another one in 0.1 and I definitely recommend this. Took me at 60 mm/s around 75 minutes to print.
UPDATE 2: After another crash, I reinforced it ab bit and printed in ABS.
UPDATE 3: Pritning in ABS did not make any difference, it brakes at the same spot. So created Version 2 to be more robust and back to PLA.
UPDATE 4: If Version 2 does not fit in your steering setup, try Version 3. :D
UPDATE 5: Added Version 4.
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.1 - 0.2
Infill:
100
The author marked this model as their own original creation. Imported from Thingiverse.