Cloudspire Spire Tower - Remix

An easy to print tower for use in the game Cloudspire.

The original model is fantasic, but I wanted to make a couple minor modifications.

1. Base ring - The original prints great with a brim, but I don't like having the rough edges, or having to sand them, so this ring is an alternative, and helps keep the shape. I did keep it on the shorter side so as not to obscure the bottom chip.
2. Tapered base - I tapered the interior of the base so that it more easily slides over the stack of chips by guiding them into the center.
3. Tapered tower walls - I found my stubby fingers couldn't easily grab the chip sitting on top of the tower, so I tapered the walls in a bit, while still leaving a low wall so that the chip slides into place.