Couch Riser : cat foot

Need another 45mm to convince your robo-friend to clean under your sofa? And you'd like a bit of whimsy?

Here are two versions of a 45mm couch riser:

1. ASA with TPU paw-pads (pictured)

   1. uses PLA supports

2. PLA with PLA paw-pads and a cutout for an adhesive flet floor protector.

   1. uses polysupport-for-pla

   2. angle and variable-layer-height set up for gradient wood effect

Printed with 0.8mm nozzle, 3 perimeters, 25% infill, variable layer height, 'soluble' supports with zero spacing and zero clearance. Should work well with smaller or larger nozzles.

1. structural changes to use as couch foot
   1. trim to length
   2. scale to size
   3. fill void (via slicer primitive)
   4. add attachment pin as a separate mesh
   5. one version adds cutout for felt floor protector (via slicer primitive)
2. multimaterial painting
3. seam painting