Road Bike Gear Cable Cross Clip [OpenSCAD]

This is a little clip to hold 2 gear cables in place 90 degrees from eachother, i wanted to to hold my gear cables out of the way of the beam from my light which is mounted underneath my garmin mount.

it should be printed at a 45 degree angle like shown in one of the pictures, to make it strong in the direction it will be flexing to press the cable in. with enough perimeters to make it solid. and I also added a little brim of 2mm and organic supports to hold up the sides.

there is an SCAD file available if you want to modify the model, you can enter the diameter of both cables (i didn't make them seperate at this moment) and the thickness of the clip, and if you want the cables to cross.