Skil Table Saw Rails

Needed new rails for my table saw for a crosscut jig - made this model to attach a wooden board as a fence.

Two versions available, one with screw holes and one without. I do not know how this will perform without an actual fence attached to it, I think it might snap at the 90 degree angle between the rail and vertical section - the preferred version is the one with the screw holes.

Printed in PLA Plus:

• 0.4mm nozzle

• 0.2mm layer height

• 15% gyroid infill

• 2 walls

• 3 top/bottom layers

It may not be perfect for long-term use - but it should be good enough to tackle a few projects for sure.