Mikrotik hAP ac3 / hAP ax3 holder RACK 10"

10inch rack holder for Mikrotik. With this it can be mounted only from behind, because hAP ac3 (ax3) is too wide to stitch it between rails.

• Printed from PETG, holes are 5.8mm, so M6 screws can be directly used.

• Use organic support for small overhangs.

• Use big zip tie in the middle, as shown on the photo.

FreeCAD 1.0.2 source file attached. If the model is useful for you, please donate few bucks to FreeCAD.