TP-Link TL-SG116E wall-mount brackets

I found Andrew's design quite useful as it rigidly fixates the switch, even when (un-)plugging ethernet cables. The present design has openings for better ventilation, since the original design was blocking the vent holes present in my TL-G116E.

I used PETG for stability reasons; had to print it lying on the heat bed as shown as I didn't want to use supports. But PLA should work nonetheless and should be even easier to print.

The original design was blocking the air vent holes of my TL-116E so I added some hexagonal holes to prevent heat accumulation.