Honeycomb Storage Wall Watch Holder

This is an adaptation of the original watch holder, but instead of using the flat base, I modified it to fit into the honeycomb storage wall. This allows you to set several watches into your wall storage, and get them off of the table. It needs to slide into an "insert" part in the honeycomb wall. If it ends up being too loose or too tight, try printing at ±1% scale until you get a good fit.

To print, make sure the flat side of the stalk is down. PLA or PETG should be fine. I guess PLA could sag if you've got a heavy watch in a hot environment.

Adapted the base of the original watch stand to slide into the Honeycomb Storage Wall