I printed the top surface using Fuzzy Skin. Very nice piece. Thank you for sharing it with us.
dual folding Wall Hook
wall hook folding out for coats or phones ( print in place ) can also be scaled to 70% (50% for the bold)
In the contest Wall Hooks
441
1708
41
8970
updated
November 26, 2023
Makes
Comments
Printed with Prusa XL and Prusament PETG.
Thank you for sharing.
You can see my printed stuff on my YouTube channel and please subscribe to the channel.
Kingroon PETG-CF, some minor "defects" on the underside of the due to overhang but not like it matters. Never going to see it anyway. Love em.
nice!, keep in mind CF is rough it will wear the loop down.
@Jack we'll see. Can always print new ones 😅. It's not like these will get (un)folded lots of times
View 2 more comments
There shouldn't be any supports needed…
@Jack The mobile slicer was complaining that I needed it. I was doing a quick print instead of printing from my desktop. In retrospect those supports were unnecessary, I agree.
I adjusted the size and space between the hooks to hang some roller blades. They are shockingly strong for the amount of material used, and print easily.
Printed in PETG with variable layer height. Attached to wall with TESA strip.
Had to use Exclusive Setting on Slicing Tolerance in order to have it work.
@Cybotage_1591584 Where did it fused? There are very forgiving .5mm clearance so i could print this at 50% (slicing middle).
@Jack Couldn't open it. Have my printer more dialed in so might give it a go again soon.
