CR10 C270 Webcam Mount for a 15mm sleeve

This is a remix of the C270 mount by dpetsel. I really liked the design of this, stays clear of the bed and gantry, attaches natively to the C270, and built in cable management.

I removed the screw mount (wasn't needed) and made the top hole big enough to accommodate some 15mm washers I'm using as solid bed mounts.

I printed at 50% infill, 3 perimeters and 3 layers top and bottom, but it's probably overkill to be honest.

If you print it laying on it's side (with the cable management channel facing up) then it requires minimal supports.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Supports:

Resolution:

Infill: