Hot glue Sleeve, shell mold for JST-XH connector

Mold for make cable shell for JST-XH or similar connectors (for battery pack).
41
292
2
3754
updated August 9, 2023

Description

PDF

Mold for make cable shell for JST-XH or similar connectors. It work with PETG and glue not to hot, about 170-180°C

Please note! I made these parts in the context of battery balancing cards. The S indicates the number of cells. And there's always one more wire than the number of cells. So a balancing plug for a 3S battery should contain 4 pins. So, if you need a 4-pin plug, you'll need to print the '3S' file.

The file 'moule-fiche-jst-xh-splited.stl' contains the separate elements needed to rebuild the mould for the number of pins you want.

https://www.youtube.com/watch?v=vetH\_S9nsAE&t=10s

1 - Put anti-attachement in the mold.
2 - Put the JST connector in the right piece.
3 - Put a few glue in the midle pieces.
4 - Place the right pieces and the center pieces together
5 - Fill the center pieces near full
6 - Put quick and tight the left pieces
7 - Wait 5 minutes for the cooling down
8 - Turn out and remove moulding protrusions

Print instructions

Unassociated tags: cable protection, protection de câbles
Category: R/C Vehicles

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License