Cardboard figure/mini holder - support free

Why redesign the classic U shaped holder?
Because we paid a lot for games like Gloomhaven, and the included holders were slightly to tight for the monsters printed on cardboard which were included. It required shimming them open, or being very very careful or you would damage the prints.

This holder has a gentle curve at the top and is more flexible, so it will not damage prints.

I included several sizes, in case you want to reuse them for other games.
For Gloomhaven, the 20mm base - 2mm gap ones will work fine.
Fill in different filaments for elite and normal mobs.

If you like this, please post a picture of them in use - it keeps me motivated to post more like this!
(You can also send me a tip)