Angled PC Watercooling Mount (240/360 mm) – Choose from Angles 15°–90°, Airflow & RGB + Clearance Test

Based on my model for fans: 

This mount allows you to install a radiator or an AIO at an angle inside your PC case. Because of the thicker size of  the radiators compared to fans alone, this uses 140mm fan mount points. This lets you direct airflow precisely to components or showcase RGB fans effectively.

Features

• Uses 140mm fan mount points

• Choose from angles: 15°, 30°, 45°, 60°, 75°, 90°

• Includes a fast-to-print clearance test to check size and fit in your PC case

• Suitable for airflow optimization or RGB showcase builds

• Strong and stable construction

Compatibility

• Supports 240mm and 360mm long radiators and AIOs (print the corresponding model)

• Fits most PC cases with sufficient internal space

• Use standard PC fan screws for attaching the mount to the case

• Use the short 3mm screws, that are included with most AIOs, to attach the radiator to the mount.

Print Recommendations

• Material: PETG recommended (for higher temperatures inside the case)

• Wall thickness: 3 perimeters (because of the screw holes)

• Infill: 10%

• Supports: The bigger angles definitely should use supports (build plate only)

Notes

• Angled variants allow bottom, side, or showcase installation depending on airflow or aesthetic goals

• Unfortunately I don't own a watercooling system, so I can't take pictures of it, but its based on my Design for fans and should work the same.

• Use at your own risk. The designer is not responsible for any damage to PCs, components, or accessories caused by using this design