Portable double yarn holder with plates

Flippy V.1  a snappy, light and portable yarn holder

(New single version will be coming up soon with also different size hole for magnet)

Made to be an easy print. There is no need for screws, simply use a piece of left over 1.75mm filament and you're good to go. The skateboard bearing can be printed too. 

The print will only take about 3h depending on your settings. I recommend organic support with adaptive cubic 15% infill, 0.20mm layer and textured plate.

Magnet size for holes are currently 4x7mm

This is the file that was used to print the 608 bearing (no need for glue):

https://www.printables.com/model/541192-print-in-place-bearings/files