A Simple and Ingenious Phone Stand

A practical and stylish Christmas gift idea
This compact phone stand is incredibly easy to print, featuring a clean design, no supports required.

The stand allows the phone to rest horizontally on all sides at 30°, 45°, and 60°, while the vertical position is optimized for 60°, thanks to a dedicated rear support for improved stability.

The sample shown includes a single color change between the base and the upper structure, but the model is fully customizable—feel free to pick any color combination you like.

Recommended print settings (as used in the photos):

3 perimeters

25% honeycomb infill

0 top layers / 0 bottom layers (for a visible infill pattern)

0.15 mm layer height

If you prefer to keep the top and bottom layers, make sure to use the Hilbert curve pattern for the top layers. It adds a clean, premium look while maintaining structural strength.

The model can be easily scaled to perfectly fit your device.

Materials: PLA, PETG, or any filament with similar print characteristics.